Morra MH 420, Руководство по сборке

Страница: 4 / 10

4
4. Put the 2 bolts back in the flange that goes over the rotor housing.
Install 2 bolts and washer in the rear and top that secures the support
to gear box cover using a 19 mm socket (top holes are bolt and nut-
bottom threads into cover)
*At this point you will need to go back and tighten all
bolts in the
assembly thus far as well as inserting the other two bolts
into the gear box cover
5.
Using a 24 mm socket, attach the tongue to the support with the two
8.8 x 80 mm bolts( one on each side) Do not tighten the nuts tightly –
you want to allow the tongue to pivot on the bolts.
6. Attach the jack stand to the tongue with the cotter key provided in
the bag of parts. It is a good idea to grease the jack before
installing it.
Top of gear
box cover
Support