INSTRUCTIONS FOR:
ALUMINIUM LOFT LADDER
Model No.:
LFT03
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1
GENERAL SAFETY
p
WARNING!
Ensure Health and Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
3
Familiarise yourself with the application and limitations of the ladder, as well as the potential hazards.
3
Maintain the equipment in good condition.
3
Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
3
Keep the work area clean, uncluttered and ensure there is adequate lighting.
p
WARNING!
Rest the base of the ladder on level and solid ground.
p
WARNING!
Never over-reach when on the ladder.
3
Keep children and unauthorised persons away from the working area.
7
DO NOT
use the ladder for any purpose other than that for which it was designed.
7
DO NOT
use the equipment if any parts are damaged or missing as this may cause failure and/or personal injury.
7
DO NOT
allow children to climb the ladder.
7
DO NOT
use the equipment when you are tired, under the influence of alcohol, drugs or intoxicating medication.
3
When not in use, stow securely.
2. INTRODUCTION
Aluminium loft ladder manufactured to BS7553:1992 class G. Complete with hand rail and all fixings with factory assembled components for
quick and easy installation. 3-Section design enables ladder to fit in smaller areas than standard 2-section ladders.
3. CONTENTS & SPECIFICATION
A
B
C
D
G
E
H
F
L
I
K
J
3.1 Contents:
Included with the ladder you should find:
A
3 x washers
B
6 x screws (31mm)
C
2 x nuts
D
2 x screws (64mm)
E
8 x screws (15mm)
F
2 x screws (18mm)
G
Pole (for opening trap door and lowering ladder)
H
Hand-rail
I
Fixing pins/screws and marker for auto latch
J
Trap door hinges
K
Auto latch
L
Stabilisers/retainers for hand rail
3.2 Specification:
No. of sections
3
Max floor to floor
3m (see fig )
Min loft clearance
1050mm
Min loft opening
432 x 508mm
Max load
100kg (15.7 stone)
3m (max)
fig 1
LFT03 - 1 - 130104
