7
7
Using in upright steam cleaning mode (continued)
5
Place the floorhead
(22)
on the floor. Hold the
floorhead to the floor with your foot and tilt the
main body
(7)
back.
Turn the variable steam control
(12)
anti-clockwise
as far as it will go to set to minimum steam. This
will avoid over-wetting the floor and allow the floor
to dry quickly (see point 6).
Squeeze the steam trigger
(2)
to release steam
from the floorhead. This will take a few seconds. To
avoid over-wetting the cloth and floor, only operate
the steam trigger intermittently. The heat and
moisture in the cloth should easily clean the floor.
Excess steam will result in the floor taking longer
to dry. Keep the floorhead moving whilst cleaning.
Never hold the cleaner in one spot for an extended
period, see opening paragraph on page 6.
6
Adjust the variable steam control
(12)
to the
required setting. Turn anti-clockwise for
minimum steam, clockwise for maximum steam.
7
If cleaning carpet, rest the floorhead
(22)
with
the micro-fibre floor cloth
(24)
attached into the
carpet glider
(23)
to make it easier to move the
floorhead across the carpet.
NOTE: The carpet glider is designed to make it
easier to move the floorhead across the carpet
and is intentionally a loose fit on the floorhead.
8
When carpet cleaning is complete, remove the
carpet glider (if used) and rest the floorhead
(22)
with micro-fibre floor cloth
(24)
attached into the
cooling rest tray
(26)
. The cooling rest tray
catches any residual heat or moisture emitted
from the floorhead to ensure it will not affect the
surface. Once cooled, remove the micro-fibre
floor cloth and wash and air dry it (see ‘Cleaning
the cloths’ under the ‘Maintenance’ section on
page 11).
VC720502MUK Rev2_Instruction Book 07/06/2013 15:41 Page 7