9
4.
Remove the foam filter
(8)
from the dust canister
filter
(9)
.
5.
Dust off the foam filter each time the dust
canister is emptied.
Every month, wash the foam filter in luke-warm
water and thoroughly air dry before re-fitting.
6.
Use the tab to pull out the dust canister filter
(9)
from the dust canister.
7.
Brush clean all parts of the dust canister filter
to remove any hairs or fibres each time the
dust canister is emptied.
8.
If necessary for further cleaning, the dust canister
filter may be separated by holding the top of the
filter and the tab at the bottom and rotating in
opposite directions, then pull the two sections
apart. To reassemble, use the reverse action.
9.
To refit the dust canister filter
(9)
back into the
dust canister
(10)
, a lign the rectangular holes on
each part and slot the dust canister filter back
into the dust canister.
10.
Refit the foam filter
(8)
into the dust canister filter
(9)
.
11.
Refit the dust canister
(10)
by locating the recess
at the top of the canister onto the mating tab on
the handheld vacuum cleaner
(6)
then push the
canister onto the handheld vacuum cleaner until it
locks into place.
IMPORTANT:
All the filters and the dust canister may be
washed in luke-warm water, but please note:
a)
Not in hot water.
b)
No detergent should be used.
c)
All the parts must be left to air-dry before
refitting.
d)
Do not use heated appliances to dry.
e)
Never use the product without the filters being
in place.
VC731011MUK Rev1.qxp_Instruction Book 05/03/2020 10:44 Page 9
