5
Set up and charging
Charge the product fully before first use.
1
Insert the mains adaptor connector
(22)
into the
charging inlet
(4)
on the side of the handheld
vacuum cleaner
(6)
. Connect the mains adaptor
into the mains supply.
2
During charging, the charge indicator lights
(7)
will illuminate with slow pulses. There are five
charge indicator lights that will illuminate in turn
as the product charges. When charging is
complete, the charge indicator lights will stay on
for five minutes before extinguishing. A full
charge will take approximately 5 hours.
When fully charged, disconnect the mains
adaptor from the handheld charging inlet and
unplug the mains adaptor from the mains supply.
In extreme conditions, batteries may be subject
to leakage. If touched, wash skin with hot soapy
water.
WARNING: Do not try to use or recharge the
battery in this condition.
Only use the battery supplied with this product.
NOTE: Always make sure the device is turned off
before charging.
2
1
Upright vacuuming: assembly
1
Push the extention tube
(14)
into the neck of the
motorised floor brush
(19)
until it clicks into place,
ensuring the electrical connectors marry together.
2
Push the handheld vacuum cleaner
(6)
into the
extension tube until it clicks into place, ensuring
the electrical connectors marry together.
1
2
VC731011MUK Rev1.qxp_Instruction Book 05/03/2020 10:44 Page 5
