4
Steam cleaning floors
If cleaning hard floors, attach the hard-floor
micro fibre cloth
(18)
to the fastening pads
(22)
on the underside of the floorhead
(16)
. The
hard-floor cloth has white fastening strips
(19)
on its upper side to be aligned with the
fastening pads on the floorhead.
1
If cleaning carpet, place the carpet micro-fibre
cloth
(20)
into the carpet glider
(21)
(either side
up), then attach the carpet glider to the
underside of the floorhead
(16)
.
The carpet glider is designed make it easier to
move the floorhead across the carpet.
2
IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry
vacuumed. However, we recommend that the steam cleaner is not used on:
•
bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).
•
damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).
Also, do not keep the mop in one place for an extended period, because the continual heat may cause
damage to carpets and laminate flooring.
Insert the handle
(1)
into the top of the upper
handle tube
(4)
(with the small clip on the
handle below the upper cord storage hook
(2)
aligned with the small rectangular hole
towards the top of the tube) until the handle
clicks into place.
If you wish to remove the handle
(1)
, press the
metal clip at the top of the tube and lift out the
handle.
Assembling the handle
1
Insert the lower handle tube
(6)
into the handle
slot
(7)
until it clicks into place.
If you wish to remove the handle
(1)
(with the
upper
(4)
and lower
(6)
handle tubes) when
emptying the water tank
(11)
, press the handle
release button
(8)
and lift the handle and tubes
out.
2
VC70465MUK Rev2_Instruction Book 25/09/2012 15:00 Page 4
