6
6
UK Helpline 0870 060 2604
Replacement Parts 0870 167 663
Ireland Helpline 1800 409119
6
SAFETY CUT-OUT
If the cleaner overheats a motor
protection thermostat will
automatically switch the motor
off. If this happens,
switch the
cleaner off, unplug from the
power supply and leave the
cleaner to cool for at least
60 minutes
. Check the
airways for blockages, empty
dust canister and clean the
filters before restarting.
CLEANING THE
FILTERS
To maintain suction the
pleated filter must be
shaken clean each time the
dust canister is emptied.
Failure to clean the filter will
reduce suction and could
damage the motor if used for a
prolonged period. This may
invalidate the guarantee. If the
filters become damaged they
must be replaced.
Pleated filter
This must be shaken clean at
every emptying to maintain
suction. To thoroughly clean it
wash it regularly.
To remove it from the dust
canister lid turn the filter 1/4
turn anti-clockwise.
G
Wash in
warm water (no detergent) and
allow to air dry before refitting.
The spare pleated filter allows
one filter to be washed and
dried whilst the other is in use.
Motor protection filter
H
The motor protection filter
Ò
is
located underneath the dust
canister
1
Remove the dust canister.
2
Lift out the filter and shake over
a dustbin.
The filter may also be washed in
water (no detergents) but must
be totally dry before re-fitting.
3
Replace the filter
Exhaust filter
I
The exhaust filter is located
below the dust canister
compartment.
1
Remove the front cover.
2
Remove the exhaust filter
Ú
by
pulling forward at the top and
lift it away.
3
Take the filter out of the cage
and shake vigorously over a
dustbin. The filter may also be
washed in warm water. Do not
use detergents. The filter must
be completely dry before re-
fitting. Allow filters to air dry
naturally.
4
Replace the filter and front
cover.
Changing the belt
If the brush bar stops rotating it
is likely that the drive belt has
snapped (usually because the
brush has been stalled). A spare
belt is supplied. Replacement
belts can also be obtained from
Morphy Richards.
Accessing the floor
nozzle
I
1
Disconnect the cleaner from the
mains supply.
2
Put switch to off position.
3
Remove front cover and dust
canister.
4
Press the handle release pedal
and place the cleaner face
down, in a flat position on a soft
surface (eg carpet).
5
Using a flat bladed screwdriver
or a coin, rotate the three cover
fixings, a quarter of a turn, from
lock to unlock
I
.
6
Lift the base cover, from the rear
fixing area first, the cover will
rotate forward. Unhook cover
from front edge and remove
M
.
H
G
I
73360 rev4 11/7/06 14:43 Page 6
