8
If, with just the hose attached, and the product
switched on at maximum, this indicator shows
red, the bag is full and must be replaced.
The dust bag full indicator
(5)
senses when the
air-flow is restricted and it may show red
intermittently during use if the hose-end or nozzle
is temporarily blocked, this is normal.
If the indicator shows consistently red and the
dust bag does not appear full, check the nozzles,
hose and tube for potential blockages.
Changing the dust bag
1.
Open the dust bag compartment lid
(3)
by
pressing the open button
(2)
and lifting the lid up
until it locks into the open position.
2.
Lift the dust bag holder handle and then lift the
holder with dust bag from the cleaner.
3.
To remove the dust bag from the holder, slide the
cardboard collar side-ways.
4.
Fold over the flap to cover the hole in the dust
bag.
5.
Dispose of the dust bag in your normal household
waste.
Replacing the dust bag
1.
To fit a new dust bag, slide the cardboard collar
of the new dust bag into the slots of the holder.
The straight end of the collar must be slid in first,
so that the cardboard closure tab is on the same
side as the red safety lock, when the holder is
refitted into the cleaner.
2.
Slide the holder with bag, into its location slots at
the front of the cleaner.
Replacement dust bags may be purchased from
our Helpline or Website. It is important that only
genuine Morphy Richards replacement dust-bags
are used, otherwise the performance of the
cleaner could be seriously impaired.
NOTE: It is very important the dust bag is fitted
the correct way around.
The red safety-lock mechanism ensures that the
dust bag compartment lid can never be closed
without a dust bag fitted. A dust bag must be
fitted to allow the lid to close.
The dust bag
Dust bag full indicator
VC700006 MUK Rev 1.qxp_Instruction Book 03/11/2014 14:49 Page 8
