Before first use
Take your coffee maker out of
the box and remove all
packaging. Wash the
detachable parts of the
machine in warm soapy
water. The first time you use
your coffee maker, operate
your coffee maker with water
only.
General use
1
Lift up the hinged reservoir lid
⁄
.
2
Fill the water reservoir with
the required amount of water
using the water level indicator
as a guide
A
.
Both the jug
‡
and the
water level indicator
„
are
marked in cups. Do not
exceed the maximum level on
the water level indicator.
3
Spoon the required amount
of ground filter coffee into the
mesh filter
›
spreading it
evenly. We suggest one level
measuring spoon
Â
for
every cup. Ensure the filter is
sitting properly in the filter
holder
fi
.
4
Close the reservoir lid
⁄
.
5
Select the strength of coffee
required using the strength
selector
¤
on the reservoir
lid
⁄ B
.
6
Slide the jug
‡
into the
coffee maker ensuring it sits
correctly on the hot plate
‰
.
The jug lid
·
must be in
place during the brewing
process, otherwise the
non-drip valve
fl
will not
open, causing the filter to
flood.
7
Plug the filter coffee maker in
at the wall socket and switch
the coffee maker ON
‚
. The
orange light will glow to show
the coffee maker is working.
8
Hot water will start to flow
through the coffee grounds
and into the jug as coffee.
9
Serve as required. The
non-drip valve
fl
will prevent
any remaining coffee dripping
onto the hot plate
‰
. Ensure
that the jug is replaced on
the hot plate after serving.
While the coffee maker is
switched ON the hot plate
will keep the coffee warm.
10 Switch off the coffee maker
when the jug is empty or the
coffee is no longer required.
WARNING: The coffee
maker and hot plate are
hot and remain hot for
some time after switching
off.
11 Allow the unit to cool.
12 Remove the permanent mesh
filter
›
and empty the used
coffee grounds.
Wash the filter immediately
and dry thoroughly.
NOTE: THE MESH WILL
BECOME DISCOLOURED
AFTER A WHILE DUE TO THE
STAINING EFFECT OF
COFFEE.
Refilling
1
Switch off the coffee maker
and allow 3 minutes to cool
before refilling with cold
water.
Locating the filter
1
To remove the filter, lift both
the holder and mesh filter out
to clean. (see cleaning)
2
To refit, place the removable
filter holder into the top of
your coffee maker, making
sure the tab lines up with the
rib
‹
. Then place the
permanent mesh filter inside
the filter holder
C
.
For details of other Morphy Richards products, please see our website:
3
A
B
C
47031 rev3_x 21/09/2011 10:01 Page 5
