DX
Local
6
Radio operation
Note: The lock switch must be set to the unlock position.
1
Switch the unit on by pressing the Power on/off button on the touch screen
display.
To obtain the maximum reception for SW and FM fully extend the telescopic aerial
which is located at the rear of the unit and alter the direction for best results.
The aerial for the MW and LW wavebands is located inside the unit. To obtain, the
maximum MW and LW reception rotate your radio.
Intermediate frequencies: FM 10.7 MHz, MW/LW/SW 450kHz.
2
Select the waveband with the Waveband switch.
3
Start the station search with the Up/hour button for searching the higher
frequencies or press Down/minute button for searching lower frequencies.
4
Pressing briefly will tune the frequency in steps. Pressing for several seconds will
tune automatically and find the next station.
The tuning steps are 50Hz for FM,
9kHz in the case of MW, 1kHz for LW manual tuning,
9kHz for LW auto-tuning
5 kHz for SW.
As a result of poor reception conditions during automatic station search it may
happen that the station received is not optimally tuned in. In such instances briefly
press the Up/hour button or Down/minute button once or twice until the station
is correctly tuned in.
Note: When the battery voltage decreases, the automatic station may not work
correctly. In this case, change the batteries if the low battery indicator
is
showing.
Sensitivity switch (SENS LOC/DC)
Normally this switch should be set to the DX position for national stations.
If the signal received is too strong, set the switch to Local for nearby
stations. (This switch functions only on FM/SW reception) If searching
for local stations switch to local to obtain optimum reception.
