Morningstar TriStar MPPT Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 37

28 Installation
RS-232 Connection
7KHVHULDO56SRUWLVDVWDQGDUGSLQ'%IHPDOHFRQQHFWRU$ORZSUR¿OHVHULDOFRQQHFWRU
is recommended to save room in the wiring box.
NOTE:
The RS-232 and EIA-485 ports share hardware. Both ports cannot be used
simultaneously.
REMARQUE :
Les ports RS-232 et EIA-485 partagent le matériel. Ils ne peuvent pas être utilisés
simultanément.
Ethernet Connection
The RJ-45 Ethernet jack features two (2) indicator LEDs for connection status and network traf-
¿F8VH&$7RU&$7HWZLVWHGSDLUFDEOHDQG5-SOXJV,ISRVVLEOHSXOOWKHQHWZRUNFDEOH
through conduit before crimping on the RJ-45 connectors. If using pre-assembled cables, take
care not to damage the plugs when the cables are pulled through conduit.
MeterBus TM Connection
MeterBus TM networks use standard 4-wire or 6-wire RJ-11 telephone cables. If possible, pull the
telephone cable through conduit before crimping on the RJ-11 connectors. If using pre-assem-
bled cables, take care not to damage the plugs when the cables are pulled through conduit.
Y-cable Connections for EMC-1 Use
TS-MPPT-30 and TS-MPPT-45 units can be Ethernet connected using the EMC-1 accessory and
an EMC-1 provided Y-cable. These models need to be connected to the EMC-1 with the Y-cable
(DB-9 serial and RJ-11 plugs at the TS-MPPT) and an RJ-11 plug at the EMC-1.