MORITEX MLEK-A120W2LR, Инструкция по эксплуатации

Страница: 3 / 13

15
Confirming Package Contents
Part name Quantity Unit Notes
Main body 1 piece
－
Power Supply Cord Set 1 piece
※
1,2
Caution Manual 1 book
－
※
1
『
MC-AC100A-2.0M
』
is attached to
『
-100V
』
model.
『
MC-AC200A-2.0M
』
is attached to
『
-200V
』
model. (It depends on the suffix of the model that was purchased.)
Before connection to the power supply, please check the conformity of the specifications of
the Power Supply Cord Set with the laws and standards of your country as well as the correct
power and temperature rating.
Refer to Page 17: Installation, Page 20: Specifications, Page 21: Optional Items
※
2 An attached AC cord set is an AC cord set for exclusive use of this product. Other than this product,
please do not use it.
2. Features
Applicable Illuminators
Requirements for applicable MG-Wave Illuminators (made by MORITEX)
※
1,2
Illuminator of up to 1.2 [A] /4pin
Output
Number of output channels: 2 channels
※
Each output channel is controlled separately.
Manual illuminance adjustment function
It is possible to adjust the illuminance of the Illuminator by using the Output Control SW on the
front-panel.
※
It is possible to control each channel separately.
※
Manual adjustment of the illuminance is possible when selecting MANU mode (MANU/REMO SW)
※
Hexadecimal control: 0,1,
・・・・
,E,F
※
(COARSE, FINE): (0,0) = MIN; (F,F) = MAX
※
Range between (0,0) and about (0,5) does not turn on the Illuminator.
Remote illuminance adjustment function
It is possible to adjust the illuminance of the Illuminator by inputting an EXT_0-5V analog voltage or
EXT_VR signal (0-2.5V / at using 2.5Vref) to the External Signal Connector on the rear-panel.
※
It is possible to control each channel separately.
※
Remote adjustment of the illuminance is possible when selecting REMO mode (MANU/REMO SW)
※
Input 0V: MIN, Input 5V or 2.5V (2.5Vref): MAX
※
It is possible to change EXT_0-5V or EXT_VR by inputting a signal to the External Signal
Connector.
Output ON/OFF function
It is possible to turn off the Illuminator by inputting a relevant signal to the External Signal Connector.
※
It is possible to control each channel separately.
※
Operation of this function is possible regardless of the MANU/REMO setting.
WARNING
※
1 Do not connect anything to output except designed Illuminator.
※
2 Please never exceed specified current values.