33
Instructions for Use 2020-01-21
If the Lubrina 2 does not seem to be working properly, first inspect the locations described below.
* If you cannot inspect the device yourself or if the device fails to work properly after being adjusted or after parts are re-
placed, contact your local dealer or J. MORITA OFFICE.
9 Troubleshooting
Symptoms
Possible Causes
Remedies
Ref.
Page
No power when the Power
Switch is turned on.
The power cord is not properly plugged into
the power outlet.
Connect the power cord correctly.
p. 13
The power cord is not properly connected to
the device.
Cannot attach handpieces. Coupling or handpiece connection is de-
formed.
Have the coupling or handpiece repaired.
N/A
Debris on the coupling or handpiece connec-
tion. O-ring is dislocated.
Remove debris. Replace the O-ring with a new
one.
Forcibly detached the handpiece without un-
locking.
Pull up the release ring.
p. 25
Lubrication does not start
when the Start/Stop Switch
is pressed.
No line is selected.
Select at least one line before pressing the Start/
Stop Switch.
p. 23
The device makes a small
noise several times when
pressing the Start/Stop
Switch.
This is not a malfunction. The device may
dispense oil more than once to stabilize the
discharge amount when the spray can is
nearly empty, etc.
N/A
N/A
Process stops immediately
when pressing the Start/
Stop Switch.
■
All Line Selection Lamps
blink
■
A triple beep sounds
The front door is open.
Close the front door properly and press the Start/
Stop Switch again.
N/A
The front door is dislocated or the hinge is not
insert properly.
Remove the front door and reinstall it. Make sure
you insert the hinge straight until it snaps on.
Process stops before lubri-
cation.
■
Selected Line Selection
Lamp and corresponding
Empty Spray Can Lamp
blink
■
A short series of beeps
sounds
Spray can is empty.
Replace the spray can with a new one.
p. 16
Spray can is not properly installed.
Fix the spray can and spray stand installation.
Compressed air is not supplied.
Connect the air tube correctly.
p. 12
Air regulator setting is not within the correct
range.
Adjust the regulator and set the pressure within
the specified range.
p. 12
Air tube is bent.
Fix the air tube.
N/A
Cannot set a spray can.
Oil leaks from a spray can.
Spray can is deformed.
Use only properly shaped spray cans.
N/A
Spray stand is not properly adjusted.
Readjust the spray stand height.
p. 17
Spray stand not designed for the spray can is
used.
Replace the spray stand with the one that corre-
sponds to the spray can.
p. 14
Spray can not specified by J. MORITA is used.
Only use spray cans that are approved by J.
MORITA.
p. 14
Odd odor from the device.
The device gets unusually
dirty.
Handpiece was not connected to the lubrica-
tion line.
Select only lines with handpieces connected.
p. 23
Oil absorbent pad is saturated.
Remove the old pad, clean the device, and set a
new oil absorbent pad.
Oil absorbent sheet is dirty.
Remove the old sheet, clean the device, and set a
new oil absorbent sheet.
Spray can is not properly installed.
Fix the spray can and spray stand installation.
Air pressure is set out of specified range.
Adjust the regulator and set the pressure within
the specified range.
p. 12