Morita Lubrina 2, Инструкция по эксплуатации, Страница: 32 / 48

30
8 Cleaning the Device and Replacing Parts
Instructions for Use 2019-07-22
8.2 Regular Cleaning: Once a Month
8.2.1 Front Door
1. Open the front door and pull straight it out.
2. Remove the door oil absorbent sheet and front door sheet stopper,
and clean them with a neutral detergent.
Dry them naturally, or wipe off moisture with soft gauze.
3. Make sure the hinge direction of the front door is correct as shown
in the illustration on the left, and insert the hinge straight until it
snaps on.
4. Check if the door movement is smooth after installing the front door.
8.2.2 Air Regulator
Place a dry cloth underneath the air regulator and push up on the drain valve. Make sure that no water comes
from the valve. If large quantities of water come out, there could be a problem with the air compressor and it may
result in poor maintenance. Contact your local dealer or J. MORITA OFFICE.
p. 12 “6.1.2 Air Tube”
Air Regulator
Front Door
Hold the device firmly with one hand and pull the front door straight out with the other
hand. Do not apply excessive force or pull it out at an angle. This could damage the de-
vice.
Hold the device firmly and insert the hinge straight in. If the hinge is inserted forcibly or
misaligned, the device could be damaged.
Do not use hot water. This could deform the plastic.
Do not use a dryer. This could damage the front door. Always dry it naturally or use soft
gauze to wipe off moisture.
Push Up
Drain Valve
Graphic Explanation
Insert
Line Up
Hinge
* The front door will not close all the way if the front door is not properly installed.
Front door does not close all the way.
* Reinstall all parts after cleaning.
Right Wrong