13
6.1 Main Unit
Instructions for Use 2020-01-21
6.1.3 Power Cord
1. Pass the power cord connector through the power cord hole and
connect the connector.
2. Plug the power cord plug into the power outlet.
• Never touch the power cord with a wet hand. You could get an electric shock.
•
Be sure to use the ground connection. Otherwise, there are risks of fire or electric shock
if the Lubrina 2 malfunctions or electric leakage occurs.
•
When connecting the power cord, connect the power cord connector to the unit first and
then connect the power cord plug to the power outlet.
Power Cord Plug
Power Cord Connector
Power Cord Hole
Power Cord Connector
4. Pull up the adjustment dial of the air regulator and then rotate it to
adjust the air pressure between 0.3 MPa and 0.5 MPa.
* Recommendation: 0.4 MPa
Increase
Decrease
Air Pressure
Do not set the air pressure less than 0.3 MPa. It could cause a malfunction.
Do not set the air pressure more than 0.5 MPa. It also could causes a malfunction.
Make sure the power cord connector is inserted all the way in. Otherwise, it could cause
a malfunction.
Hold the connector itself when you connect/disconnect the power cord. Holding the cord
could cause a broken connection or a malfunction.
• Set the input air pressure at 0.7 MPa or less. Otherwise, there is a risk of bursting the air
tube.
• Oil mist may occur depending on the type of handpieces and couplings. If so, lower the
air pressure to 0.3 MPa.
*
Cord type and plug shape depend on your country or region.