PREPARATION BEFORE STARTING MASS PRODUCTION E-9
5
CHECKING A PROGRAM USING MACHINE LOCK FUNCTION
This section describes the procedure used for checking the program stored in the NC by
displaying the list of the program on the screen while executing it using the machine lock function.
Since the program is executed in the machine lock status, the axes do not move but only the
position data on the screen is updated as the program is executed.
When using the NC functions, refer to page A-23 (5-6) to find the details of them.
1)
Carry out the procedure explained in 4-1
"Preparations for Checking a Program".
2)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
3)
Close the front door.
4)
Place the PANEL key-switch in the
(ON)
position.
5)
Carry out the zero return operation.
6)
Display the OPERATION PANEL screen.
Function selection key
(CUSTOM1)
[OPE. PANEL]
7)
Move the cursor to MACHINE LOCK "ON" to make
the machine lock function valid.
For items 8) and 9) below, determine whether or
not the corresponding function should be used.
8)
Press the single block switch
to make the
single block function valid.
9)
Press the dry run switch
to make the dry run
function valid.
NOTE
DOOR INTERLOCK
ON
PANEL
/EDIT
OFF
PANEL
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
NOTE
SBK
OSP
BDT
DRN
