Morgana BM 60, Руководство оператора

Страница: 20 / 33

T10170 OPERATOR MANUAL BM 60
19
4. Operator instructions
4.1 Settings
4.1.1 Stapling and folding
1. Open the top cover.
2.
With the double/single stapling switch select double stapling.
3. Position the stapler heads above the correct anvils (check table in section 4.1.8).
Position the stapler heads as in figure below, right above the anvil.
4. Adjust the side guides to proper paper size by loosening the side guide screws.
5. Insert one set.
6. Turn the paper stop crank until the trail edge of the set is in line with the scale for
paper length.
7. Make the final adjustment by loosening and moving the right side guide up against the
set and then back 1 mm.
8. Load the stapler magazines. By pressing the stapler magazine release button the
magazine will come out.
NOTE: Use only Chisel point staples P/N 800001.
9. Close the top cover.
10.
Set Delivery Tray for correct paper size according to scale by loosening the knob.
NOTE: This does not apply if you are using the Belt Stacker.
11. Set the stapling switch to
ON
position.
12. Set the folding switch to ON position.
13. Continue to section 4.2 OPERATION.