Morgana AutoCreaser Pro 33, Руководство по обслуживанию

Страница: 6 / 39

Page 6
CREASING
SECTION 1
1.1
1.2
1.3
The Front Cover
The Rear Cover
The Creaser Mechanism Cover
The front cover which is situated below the feed bed also covers the compressor and is
secured by 13 taptite screws and is located by three tongues protruding into the main frame.
To remove this cover, remove all screws and twist forwards to clear emergency stop button
and mains socket, pull out to release the tongues.
The rear cover is at the opposite side and is secured by four screws. This cover is removed by
lifting up and outward to unhook the keyhole locations on the opposite side to the screw fittings.
This allows access to the electronic plate assembly.
The creaser mechanism is situated towards the delivery end of the machine and is covered by
a fixed and a hinged guard.
To remove these guards just remove the four screws (M4 x 8 long) beneath the infeed guard.
Pull off the rubber handle from the tilt lever, and remove the knurled knob, the infeed guard can now
be lifted upwards and removed.
This allows access to the suction valve assembly and the compressor.