7
INSTALLATION INSTRUCTIONS
INSTALLING BOTTOM COVER
1. Unplug the power Cord of the washer.
2. Gently lay down the front side of the washer on a soft mat or cushion. (Be careful
not to dent the frame.)
3. Insert the attached Bottom Cover onto the hooks of the leg by pushing until reaches
into the front hooks.
4. Fasten the Bottom Cover with screw.
5. Gently set the washer upright.
6
INSTALLATION INSTRUCTIONS
WHERE TO PLACE THE WASHER
1. Choose a dry location and away from exposure to direct sunlight.
2. Install the washer on a stable and level surface.
3. Adjust the adjustable Leg of the washer if necessary, to level the washer as
shown in the figure.
4. Use the gradienter to ensure washer is evenly placed.
CAUTION:
• Do not block the ventilation opening at the bottom of the washer, by
placing the washer on a carpeted floor.
ATTACHING THE “MAGIC” HOSE JOINT TO A TAP
Type A: Is the most suitable
Type B: The length of the mouth of tap needs to be at least
16mm. If it is less than 16mm, the “Magic” Hose Joint
can’t be installed.
Type C: It may cause water leakage.
CAUTION:
• Do not use water which is warmer than 50ºC
• If your tap is not suitable, please consult the authorized service center.
HOW TO ATTACH “MAGIC” HOSE JOINT
1. Loosen the four screws and slide the top of the “Magic” Hose Joint (section A in the figure) onto the tap. Then,
securely tighten the four screws provided with the
“Magic” Hose Joint by using a screwdriver to secure the
top of the joint to the tap.
2. Remove the CAUTION label from the “Magic” Hose Joint.
3. Turn the male coupler on the joint (section B in the figure)
clockwise to attach it securely to the top of the joint
(section A in the figure).
• The appliance is to be connected to the water main using
the new Water Supply Hose and “Magic” Hose Joint and
old hose-sets should not be reused.
CAUTION:
If the outer diameter of the tap is larger than the caliber of the Joint Ring, loosen
the four screws and remove the Joint Ring from the “Magic” Hose Joint.
INSTALLING WATER SUPPLY HOSE TO THE WASHER
• Turn the nut clockwise while holding the hose.
CONNECTING THE WATER SUPPLY HOSE TO “MAGIC” HOSE JOINT
1. While pushing the sleeve on the female coupler (section D in the
figure) of the joint down with your finger, connect the female coupler
to the male coupler (section C in the figure).
2. Release the sleeve, then push the Water Supply Hose up into the
“Magic” Hose Joint until it clicks into place.
3. Pull the Water Supply Hose down to make sure that it is securely
attached.
HOW TO DETACH THE WATER SUPPLY HOSE
Please read the following procedure in order to avoid spilling water when detaching the Water Supply Hose.
1. Turn off the tap.
2. Press the Power ON/OFF button to turn on the power, the NORMAL button and
the START/PAUSE button.
3. Press the POWER ON/OFF button to turn the power off 15 seconds later.
4. While pushing the lock lever and the sleeve on the female (section D in the
figure) of the joint down with your fingers, detach the female coupler from the
male coupler (section C in the figure).
5. Turn the water inlet hose anti-clockwise on the water inlet valve, until it gets
detached.
INSTALLING THE DRAINAGE HOSE
Place the clip part of the Hose Band sideways to prevent it from touching
the frame which may cause a vibration noise.
MWM-680FA(IM)130312_Layout 1 3/13/12 3:22 PM Page 4
