5
PARTS IDENTIfICATION
4
1. Never put your hand(s) into the Wash/
Spin Tub while the washer is operating.
• Reaching your hands into the
washing machine during operation
may cause serious injuries.
• If the Wash/Spin Tub does not stop within 15 seconds
after the Washer Lid is opened, turn the washer off
immediately and call a service person.
2. Ensure the power plug and power cord
are properly connected to the washer.
• An improperly connected power plug
may pose a fire hazard.
• Never disconnect the washer by
yanking on the power cord. Hold the
power plug as you pull it out.
• Never disconnect/connect the power plug with wet
hands as it may cause electric shocks.
3. Be sure not to bring any type of
flame near the washer or put lit
cigarettes or volatile materials on
the top of the washer.
4. Never wash laundry stained with
benzene, kerosene, thinner or
gasoline.
• It may cause a risk of fire explosion.
5. Do not install the washer in the
bathroom or humid place.
• It may cause malfunction or an
electric shock.
6. Do not allow children to play on or
near the washer
• If a child accidentally falls in to the
Wash/Spin Tub, serious injury can
occur.
7. Be sure not to splash or pour water
on the Control Panel.
• It May cause a malfunction or
electric shock.
8. It is not recommended to allow your washer
to be repaired by an unqualified person.
Repair must only be carried out by a
qualified technician.
Washing Machine Body
Use soft cloth to wipe off excess water
or dirt on the surface of the washer.
• Do not spray directly onto the
washer body.
• Detergent and other chemicals are not to be used on
the surface
Water Inlet Valve
(Recommended to clean every 6 months)
• The water inlet mesh bag may be
blocked, please remove the water inlet
hose, take out the water inlet mesh bag
from the water inlet valve, clean the
mesh bag, then assemble the mesh bag
in the valve and attach the water inlet hose.
“Magic” Hose Joint Filter
(Recommended to clean every 6 months)
• Pull the water inlet hose out.
• Turn off the revolver according to the
figure shown.
• Load off the “Magic” Hose Joint Filter and
clean the crud with a toothbrush.
• Install the clean “Magic” Hose Joint Filter to revolver
and water inlet hose.
Lint Filter
(Recommended to clean every week)
• Take out the lint filter
• Wash the lint filter with water.
• Install the filter (Align the frame
claw to the groove below)
CAUTION: Lint filter is fragile
WARNING
CARE AND MAINTENANCE
ACCESSORIES
Instruction Manual
Drainage Hose
Water Supply Hose
Magic Hose Joint
Bottom Cover
Screw
MWM-680FA(IM)130312_Layout 1 3/13/12 3:22 PM Page 3
