WATER INLET INSTALLATION
Use the new hose supplied together with the machine. Do not reuse old hose.
9
8
Ensure front end is longer than 10mm & tap exit end face is flat and smooth to avoid leakage.
CONNECTING THE INLET HOSE CONNECTOR WITH THE WATER TAP
1. Press the lower end of the lock lever and push down the slider. Remove inlet hose connector from
the inlet hose (see illustration 1).
2. Loosen the four bolts on the inlet hose connector to access the tap. Then set the inlet hose connector
to the tap (see illustration 2)
Note: If tap calliper is unable to fit into the inlet hose end, unscrew the four bolts and remove
the bushing.
Important: Tap exit end must be flat otherwise it will leak
(see illustration 3).
3. Fasten the four bolts in the inlet hose connector evenly (see illustration 4).
4. Turn the fastening nut (see illustration 5).
Note: Before turning the fastening nut, ensure threading is about 4mm above the upper
surface of the nut and less than 2mm above the upper surface of the nut after securing
(see illustration 6).
(Illustration 1)
(Illustration 4)
(Illustration 5)
(Illustration 6)
(Illustration 2)
(Illustration 3)
WATER INLET INSTALLATION
CONNECTING INLET HOSE TO THE WASHING MACHINE
1. Do not remove the water absorption
cushion.
2. Inspect if water absorption cushion is
dropped or damaged before every
operation.
3. If it is, contact your authorized service
agent immediately.
4. Attach the inlet hose nut on the inlet valve connector.
5. Fasten the inlet hose nut and swing it gently to make secure the connection.
CONNECTING INLET HOSE CONNECTOR WITH THE INLET HOSE
1. Push down the slider & insert the inlet hose into the connector.
2. Hang the lock lever to the inlet hose connector and release the
slider until a click sound is heard.
CHECK CONNECTION BETWEEN INLET HOSE
CONNECTOR & TAP
1. Swing the inlet hose gently to ensure it is fastened & secure.
2. After installation, turn on tap to inspect for leaks.
3. Do not bend/twist or distort the inlet hose.
4. Inspect proper connection between inlet hose
connector and the tap before every operation.
5. Ensure they are secure to prevent & not loose.
DISMANTLING INLET HOSE
1. Turn off the tap.
2. Press the locking lever, push down slider & detach inlet hose.
3 Leave inlet hose connected to the tap if machine is used frequently to
prevent damaging the fixing screws.
