7
6
INSTALLATION & ADJUSTMENT
WATER DRAINAGE
To ensure the drain hose drains smoothly:
1. The height of the drain hose should be less
than 10cm to ensure proper drainage.
2. Do not step on or distort the drain hose.
3. Cut the drain hose if it is too long. Cut the
front end of the drain hose slant to ensure
drainage is smooth.
4. Purchase a longer hose for longer drainage
with diameter not less than 30mm and
length not exceeding 1.5m.
5 Cut at Points A or B if the additional drain
hose is too long.
<10cm
≤1.5m
≥ø30mm
<
A
B
USING THE DRAIN HOSE
It is important to install and adjust the machine according to the requirements of
the manual for your safety and correct operation
UNPACKING
• Unpack carton & detach bottom panel.
• Open the top lid of the machine and remove all accessories. Remove all wrappers, including the
polystyrene base.
• It is recommended to keep the packaging for reuse in case the machine is to be transported again.
INSTALLING THE BOTTOM COVER
• Lean the machine forward gently and insert the bottom cover (the side
with instructions) into the notch along arrowhead direction.
• Fix the bottom cover on the washing machine base with two tapping
screws in the provided accessories by using a cross screwdriver.
POSITIONING
The distance between the washing machine and the wall should preferably exceed 50mm, and the
maximum allowed angle of the shank base of the machine is 1º. Slanting or uneven ground may cause
operation to stop. It is recommended to adjust with the
following methods:
Make it horizontal
Use a tied thread with plumb to ensure it is horizontal.
Adjust the adjustable feet
• Lift the adjustable foot gently, loosen the adjustable nut
and twist the adjustable foot.
• Fasten the nut after adjustment.
Notch
Bottom panel
The baffleplate
(
The baffleplate
(
Loosen
Fasten
Adjustable
nut
Adjustable
foot
High
Low
G
The baffleplate
(
