Morgan MVP66, Инструкция по эксплуатации

Страница: 6 / 8

REAR PANEL
Speaker Jacks: Your amp is equipped with one 16 ohm and two 8 ohm speaker outputs. The amplifier
should only be operated with a SPEAKER cable connected to the proper impedance output. The two 8
ohm jacks are wired in parallel. If you want to run 2 cabs they need to be 16 ohms and each connected to
the two 8 ohm output jacks
Boost Level: This knob controls the amount of extra boost will be avail when the boost is engaged.
ON: This switch will engage the boost when the footswitch is not being used.
Footswitch: This input is for a single button latching footswitch to engage the boost remotely
MAIN FUSE: Replace with a 2 Amp slo blow fuse for 120V or 1.5 Amp slo blow for 230V. If this fuse blows
the most likely the result of a bad tube. Constant blowing of this fuse (even when using new tubes) is an
indication that something could be seriously wrong with your amp. STOP and call us so we may help you
diagnose.
MAINS INPUT: Plug the supplied IEC power cord here and into a 115v wall outlet to power the amplifier.