FRONT PANEL
POWER SWITCH
: Turn this ON to power the amplifier. Turn on this switch and the standby switch at the
same time for optimal tube life.
STANDBY SWITCH:
Turn ON this switch to put the amp in play mode. This switch should be utilized to
put the amp into a wait state for extended periods of rest. It removes high voltage from your tubes.
Gain:
This controls the amount of gain the amp has. The higher the setting the more overdrive to the
preamp tubes you will have. Using this control over the 11:00 mark will result in an overdriven signal. Use
this control in conjunction with the volume control to set your overall drive settings.
Vol:
This controls how loud the amp is. The vol control is actually controlling the amount of gain in the
power section of the amplifi
er. If you are trying to stay as clean as possible stay below 3 o’clock on this
control.
Treb :
This control sets the level of high frequencies in the amplifier. This control is interactive with the
Bass and Mid controls.
Mid :
The Mid control sets the level of the Mid frequencies. It also behaves to increase the overall level
of the entire tone stack. Setting this control to max will increase the overall gain level of the amplifier.
Bass:
The Bass control sets the level of Low frequencies provided by the amp. It is interactive with the
Treb and mid controls.
Power Level :
Turning this knob counter clockwise will decrease the voltage available in the output
section of the amplifier. Think of this like a zoom lens for volume. It allows you to go between one watt
and 50 watts. Set your gain level with your Vol control and then lower the Power Level to the volume you
require.
INPUT:
This is where you plug your guitar cable into.
Содержание MVP66
Страница 1: ...M V P 6 6 INSTRUCTION MANUAL...
