Instruction Manual
SAFETY PRECAUTIONS - LED PRODUCT
Dear customer,
we are delighted that you have chosen a Moree product.
GB
- Before using the product, please read the safety precautions
fully. Keep the manual for the entire life of the product.
- IMPORTANT
THE PRODUCT MAY ONLY BE CHARGED IN DRY ROOMS. THERE
MUST BE NO MOISTURE ON THE CHARGING POINT OR ON
THE CHARGER.
- The product may only be used when positioned vertically, with
the top facing upwards on firm, non-flammable ground and
should not be covered.
- The product may only be charged with the supplied
charger.
- Make sure your voltage corresponds to the voltage printed
on the product.
- Stop operating the product immediately if it emits smoke,
a strange smell, or otherwise behaves abnormally.
- The product may only be used after correct installation. Discon-
nect the product from the mains supply before opening.
- Do not allow dirt or metal objects (such as keys) to contact
the charging point.
- Avoid dropping or subjecting the product to severe impact.
- Do not pull on any cables !
- Do not alter the product in any way. Faulty or unqualified
repair work may cause injury to the user.
- If the appliance (including cord and charger) shows any defect, stop
using it and only replace damaged components with specific ones
that are available from the manufacturer or a representative.
CAUTION!
WHEN DISASSEMBLING DO NOT LOOK DIRECTLY INTO THE
OPERATING LIGHT SOURCE - RISK OF IRREVERSIBLE EYE
DAMAGE!
Wipe the product with a soft, damp cloth only. Do not use
abrasives, alcohol or solvent based cleaners.
Maintenance
SAFETY PRECAUTIONS - CHARGER
This unit corresponds to the directive for electromagnetic
compatibility and to the low voltage directive.
ATTENTION! THE UNIT IS SUPPLIED WITH HAZARDOUS
MAINS VOLTAGE (230 V~). LEAVE SERVICING TO SKILLED
PERSONNEL ONLY.
IMPROPER OPENING OF THE DEVICE, OTHER TAMPERING
OR CHANGES TO THE DEVICE WILL VOID THE WARRENTY.
- Use only recommended power sources.
- Only use the unit for recharging 12 V lead batteries.
- The unit is suitable for indoor use only. Protect it against
any water contact, high air humidity and heat (admissible
ambient temperature range 0 – 40 °C).
- Do not place any objects filled with liquid on the unit, e.g.
a glass.
- Do not allow dirt or metal objects (such as keys) to contact
the charger terminals or plug. This could result in fire, elec-
trical shock or other damage.
- The heat generated within the unit must be cooled. There-
fore, never cover the housing.
Specifications LED Product
Construction Diagram
SAFETY PRECAUTIONS - BATTERY
THE PRODUCT MAY ONLY BE CHARGED WITH THE
SUPPLIED CHARGER.
THE BATTERY MUST ONLY BE CHANGED BY QUALIFIED
PERSONNEL USING THE SAME BATTERY TYPE !
DO NOT ATTEMPT TO DISASSEMBLE, ALTER OR APPLY
HEAT TO THE BATTERY !
In case of leakage, do not allow liquid to come into con-
tact with skin. If liquid is spilt on clothes or skin immedi-
ately wash off with water. Should problems occur, contact a
doctor.
Charging the battery
To charge the battery, first plug the charger into the charging
point and then connect the charging plug to the power supply.
Before use charge the battery fully.
The product will automatically shut off when the battery is
empty. It will turn on again when the battery is recharged -
this may take up to 3 hours.
In order to maintain a longer battery life, please comply with
the following instructions when using this product:
If the product is not used for a long period of time please
turn it off, because the standby mode will slowly empty the
battery.
When the product is stored under 25°C it can be left for up
to 3 months. If left for longer than this period, make sure to
charge it fully again.
Please replace the battery after the correct time interval
shown below, and do not continue to use the battery after its
recommended replacement time.
Temperature
Replacement
of battery surface:
time:
Below 25
o
C (77
o
F)
6 Years
30
o
C (86
o
F)
4 Years
40
o
C (104
o
F)
2 Years
If the battery is quickly depleted even after charging, it has
reached the end of its life span. Purchase a new battery.
Remote Control
- Unplug the battery charger from the power outlet after re-
charging is complete, or when you are not using it.
Do not operate the unit or immediately disconnect it from
the mains socket:
1. if there is visible damage to the unit or the mains cable,
2. if a defect might have occurred after the unit was dropped
or suffered a similar accident,
3. if malfunctions occur.
- In any case the unit must be repaired by skilled personel.
- A damaged mains cable must be replaced by the manufac-
turer or authorized, skilled personnel only.
- Never pull the mains cable to disconnect the mains plug
from the socket, always seize the plug.
- For cleaning only use a dry, soft cloth; never use chemi-
cals or water.
- No guarantee claims for the unit and no liability for any
resulting personal damage or material damage will be ac-
cepted if the unit is used for other purposes than originally
intended, if it is not correctly connected, operated, or not
repaired in an expert way.
Operation
1) Connect the mains plug of the charger to a mains socket.
The LED is illuminated to indicate operation. The charging
process has ended when the LED is lit green.
2) The charging time depends on the capacity and the charg-
ing status of the battery.
TROUBLESHOOTING
1) THE UNIT DOES NOT WORK
When the Battery is empty
Solution: The product turns off automatically when the bat-
tery is empty due continuous use. It will turn itself back on
when the battery has been charged to a minimum level. This
can take approx. 1-3 hours to reach the minimum operating
voltage. Charge the product until the LED is lit green.
When one or both fuses are defect
Solution: Check fuses and replace if necessary. Make sure
that the charger is plugged into the product before plugging
into the mains (otherwise the fuse may blow). Keep product
away from moisture.
When the light on the charger is not lit
Solution: Check the power supply, if the light on the charger
is still not lit, the charger is faulty.
When the charge is interrupted
Solution: Make sure the charger is correctly plugged into the
socket of the unit !
When the charge is to short
Solution: Charge the product until the LED is lit green.
2) THE REMOTE CONTROLLER DOES NOT WORK
a) The battery is empty or the batteries are inserted the
wrong way round.
b) Point the remote controller at the unit from different
angles.
c) Switch the LED product off or pull the plug to reset it.
Off/ reset-button
[1] Colour selection cycle
(Red-Yellow)
[2] 90 second RGB colour change
programme
[1] Colour selection cycle
(Blue-Magenta)
[2] 3 minute RGB colour change
programme
[1] White light
[2] Warm white light
[1] Colour selection cycle
(Green-Cyan)
[2] Pulse programme
Colour selection button; can be used
at any time to choose the colour
being displayed. To activate the
previous programme or choose
other programmes please push the
off/ reset button.
[1]
Single Press [2] Double Press
Before use remove the battery’s protective sheet.
Note: Colours printed on the remote may differ from those
displayed by the LED unit.
Dimensions:
approx. 46 cm, H 89cm
Material/ colour:
PE, white translucent
Weight:
approx. 19 kg
Illuminant:
Multicolour LEDs, max 13W
SLA Battery:
12V, 18Ah
Operating time
IR approx. 25h, RC approx. 30h
Protection class:
III
Protection grade:
IP 20, for indoor use only
Charger:
220/240V~ 50/60Hz, Vout 12V, 3A
ON/OFF
button
Charging
point
2x
Fuses
Removable Ice Bucket
Bottom View
Charger
Moree product appliances meet
European safety standards.