Checking the Power Supply Setting
For your own safety please read the following instructions carefully before
attempting to connect your MS502 unit to the mains.
• Check that your unit indicates the correct supply voltage.
• If your mains supply voltage is different, consult your dealer.
This unit is designed to operate only on the supply voltage and type that is
indicated on the unit. Connecting to other power sources may damage the unit.
Safety Precautions
This equipment must be switched off when not in use and must not be used
unless correctly earthed. To reduce the risk of electric shock, do not remove
the unit’s cover. There are no user serviceable parts inside. Refer servicing to
qualified service personnel. If the power cord is fitted with a moulded mains
plug the unit must not be used if the plastic fuse carrier is not in place. Should
you lose the fuse carrier the correct part must be reordered from your
Mordaunt-Short dealer.
The lightning flash with the arrowhead symbol within an equilateral triangle
is intended to alert the user to the presence of uninsulated ‘dangerous
voltage’ within the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance
instructions in the service literature relevant to this appliance.
This product complies with European Low Voltage
(73/23/EEC) and Electromagnetic Compatibility
(89/336/EEC) Directives when used according to this instruction
manual.
SAFETY PRECAUTIONS
Plug Fitting Instructions (UK only)
The cord supplied with this appliance is factory fitted with a 13A mains plug fitted
with a 3A fuse inside. If it is necessary to change the fuse, it is important that
a 3A one is used. If the plug needs to be changed because it is not suitable for
your socket, or becomes damaged, it should be cut off and an appropriate plug
fitted following the wiring instructions below. The plug must then be disposed
of safely, as insertion into a 13A socket is likely to cause an electrical hazard.
Should it be necessary to fit a 3-pin BS mains plug to the power cord the wires
should be fitted as shown in this diagram. The colours of the wires in the mains
lead of this appliance may not correspond with the coloured markings identifying
the terminals in your plug. Connect them as
follows:-
• The wire which is coloured BLUE
must be connected to the terminal
which is marked with the letter ‘N’ or
coloured BLACK.
•
The wire which is coloured BROWN
must be connected to the terminal which
is marked with the letter ‘L’ or coloured
RED
•
The wire which is coloured GREEN/
YELLOW must be connected to the terminal which is marked with the letter
‘E’ or coloured GREEN.
Note
If your model does not have an earth wire, then disregard the Earth instruc-
tion.
If a 13 Amp (BS 1363) plug is used, a 3 Amp fuse must be fitted, or if any other
type of plug is used a 3 Amp or 5 Amp fuse must be fitted, either in the plug
or adaptor, or on the distribution board.
E
GREEN /
YELLOW
BLUE
FUSE
BROWN
CORD
GRIP
N
L
10
This product complies to the requirement UL 1270
and is approved by CSA-International for sale in the US
