CUTTING HINTS
The M
PQFD
5000 oscillating saw has been designed and constructed to provide effortless
and highly efficient cutting in its appropriate areas of usage. We suggest a trial cutting
period applying the least pressure possible to the workpiece until fully accustomed with
the efficiency. Excessive pressure is not required as this will reduce the speed of cut.
If you experience di
ffi
culty then consult the Troubleshooting Causes and Solutions on pages
10 and 11.
Suitable safety protection must be worn at all times during cutting.
DISINFECTION AND STERILIZATION
The saw unit only is capable of withstanding temperatures between -
degrees
'
to
+
degrees
'
. This must be born in mind when considering a disinfection or
sterilization method.
Autoclaving of this equipment is not recommended.
Only use cleaning agents that are safe for use on metals. We do not recommend the use
of Hy
QPDIMPSJUF
or corrosive cleaners as possible corrosion could result.
We advise gentle scrubbing with a soft non metallic brush, rinsing with clean water and
drying where necessary. Do not direct high pressure water jets at any part of the equipment,
this could invalidate the warranty.
All cleaning agents should be mixed, stored and applied according to the manufacturers
instructions.
8FTVHHFTUBOPODBVTUJDEJTJOGFDUBOUTVDIBT
#&
4BOJ1BUI%JTJOGFDUBOU'PBNJOH
4QSBZ
PS
#&
4BOJ1BUI%JTJOGFDUJOH4QSBZ$MFBOFS
GPSDMFBOJOHQVSQPTFT8F
SFDPNNFOEZPV
/0564&
BCMFBDITPMVUJPOUPDMFBOZPVSVOJU
Medezine Limited
Churchill Way Chapeltown
Sheffield England
S35 2PY
T
F +44 (0)114 257 6222
E [email protected]
W www.medezinesaws.com
+44 (0)114 257 6002
2002/289
