23
7.
With the modular tops installed correctly onto the
alignment pins, secure the front latches (4).
8.
Install and secure the rear thumb bolts (3).
9.
Secure the rear clamps (2) fully.
10. Secure the center clamps (1) fully.
11. On the left rear corner of the hard top interior (1) con
nect the hardtop wire harness connector (2).
12. Connect the hardtop washer hose to the rear washer
nozzle nipple (3).
13. Continue to radio installation Step #22.
UPDATE VEHICLE CONFIGURATION
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
1.
VIN must be updated with the sales code of the added accessory in order to enable system functionality. Using the
DealerCONNECT website and the wiTECH diagnostic application, complete the vehicle configuration.
2.
Log on to https://dealerconnect.chrysler.com.
3.
In the "Vehicle Option" screen under the "Global Claims System" category in the "Service" tab, enter the vehicle
VIN, four digit pin number obtained from the dealership parts department and add sales code(s) noted below as a
"Dealer Installed Option".
RHB (AM/FM/DVD/HDD with SDARS)
RSC (Satellite)
4.
Confirm that the new sales code has been successfully added to the VIN.
5.
With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Select "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
Dec 31, 2010
K6861157 Rev. 1
