1. Properly adjust handle assembly so the clamp is 1-2 mm
beneath the cargo rail opening (Fig. 3-a and Fig. 3-b).
2. Tilt the handle slightly to insert the locator into the slot of
the bow support (Fig 3-a).
3. Secure the clamp to the cargo rail by pulling the
handle rearward (Fig. 5-a).
Installing the tonneau cover on the vehicle (continued)
Installing the tonneau cover on the vehicle (continued)
3B
Correct Angle
Wrong Angle
Handle must be at lowest position when inserting clamp into rail.
Be sure the handle is approximately 15
0
from center.
Securing the FRONT clamps to cargo rail and clamp adjustment procedure
Securing the FRONT clamps to cargo rail and clamp adjustment procedure
TIGHTEN
LOOSEN
POINTED TIP MUST
BE IN GROOVE
Double check that the locator is in the slot and that the tonneau
has compressed the side seals to the bedrail covers. If the
handle seems loose or the tonneau can be moved/shifted easily,
follow procedure below.
1a. If clamp is too loose
1. Push handle forward to release from clamped position.
2. Disengage clamp from inner lip of bed rail and slide
assembly inboard.
3. Adjust clamp height on bolt by rotating the entire
clamp/handle assembly CLOCKWISE (as
viewed from the top).
4. Re-attach clamps as indicated in steps 3 and 4.
1b. If the handle can’t be fully pulled rearward (as shown):
1. Return handle to the fully disengaged position.
2. Disengage clamp from inner lip of bed rail and slide
assembly inboard.
3. Adjust the clamp height by rotating the entire clamp/
handle assembly COUNTER-CLOCKWISE.
4. Re-attach clamps as indicated in steps 3 and 4.
Tonneau locking feature (front clamps only)
Tonneau locking feature (front clamps only)
5
Unfolding tonneau and completing the installation
Unfolding tonneau and completing the installation
Attach the rear clamps to the cargo rail
Attach the rear clamps to the cargo rail
6
1. Unfold cover (Fig. 6-a).
2. Repeat Steps 3B and 4 for rear clamps.
1. There are locking features on front clamps only. With the handle en-
gaged (clamped position), push the locking tab on the handle to engage
lock. See Fig. 5-a.
2. Repeat clamp attachment steps 3B thru 5 for the opposite side.
Fig. 3-a
Fig. 3-b
Fig. 5-a
4
This angle will put
handle at lowest
position.
Handle
Tip of clamp is 1-2 mm
from slot opening of
rail on side of vehicle.
Slot
Locator
Put handle in
lowest position
K6860665
Fig. 6-a