MINITAUR CV MAPPING
Your Minitaur is equipped with a variety of Control Voltage inputs. These control voltage inputs can receive an
analog signal from a Moog expression pedal, Moogerfooger, or analog synthesizer.
The values arriving at the Minitaur can be re-routed to perform real-time control over certain sound creation
parameters. This also allows Minitaur to act as a CV to MIDI converter.
Page 7
PITCH CV MAPPING
Select the parameter to be controlled using the signal
connected to the Pitch CV input of your Minitaur.
VOLUME CV MAPPING
Select the parameter to be controlled using the signal
connected to the Volume CV input of your Minitaur.
GATE CV MAPPING
Select the parameter to be controlled using the signal
connected to the Gate CV intput of your Minitaur.
MINITAUR CV CALIBARATION UTILITY
Your Minitaur is an analog synthesizer. The Note Calibration utility keeps the Minitaur’s analog oscillators in tune.
NOTE CALIBRATION START
When Note Calibration Start is selected, the Minitaur will
begin to tune each of the notes in its range, playing each
note from lowest to highest. This procedure takes a few
minutes to complete, and will then automatically stop.
NOTE CALIBRATION STOP
Because the Note Calibration takes a few minutes to
complete, you may find yourself in a situation where you
want to stop the Note Calibration before it is completed.
Simply select Note Calibration Stop to halt the calibra-
tion procedure.
In addition, the Minitaur is designed to interface with electronic music equipment, using either MIDI or the CV
(Control Voltage) inputs. Normally, the Minitaur defaults to the popular 1 Volt per Octave CV standard. It is also
possible to modify this CV setting to match your specific controller. To calibrate the Control Voltage response to
match your controller, first connect your Control Voltage controller to the Minitaur’s CV input.
PITCH CV CALIB1V
On your CV controller, play note C1 and click the Pitch
Calib1V button.
PITCH CV CALIB4V
On your CV controller, play note C4 and click the Pitch
Calib4V button.
Your Minitaur is now set to match the Control Voltage settings of your CV controller. Because these two notes are
three octaves—and therefore three volts—apart, your Minitaur will now respond properly. If you are using some-
thing other than a keyboard, just be sure to select two notes that sound three octaves apart.
RESTORE DEFAULT CV CALIBRATION
Click on this button to restore the default CV calibra-
tion settings.
20
