MN00178
1359
Specifications
PAN & TILT
TInput Voltage
10 to 30 VDC
Power Requirements
Positioner w/Visible camera requires 60W during initialization or at start of move,30W during continuous motion, 11W at idle. If heaters
are activated, an additional 72W is required. The FLIR Tau camera used in thermal imager models requires an additional 1.2W
(approximate). Illuminator requires 45W, provided on separate power leads
Pan Range
Continuous pan rotation, non-continuous selectable. Soft limits adjustable for non-continuous pan, no soft limits for continuous pan
Pan Speed Range
0.25º to 100º /sec with QuickShift® technology
Tilt Range Mounting
Soft limits adjustable to ±90º max. (180º total) from horizon (parallel to P&T surface.) Factory default setting is 90º down, 90º up. Hard
stops set approximately ±95°
Tilt Speed Range
0.25º - 100º / sec. with QuickShift® technology
Motor Type
Stepper motors are used for both Pan and Tilt axis
Wiring
26 Pin Connector on bottom of unit
System Dimensions (H x W x D) 7.25" x 14.25" x 10.5" (185 x 362 x 266.7mm)
System Weight
24 lbs. (10.9 kg) approximately with dual cameras
Drivetrain
Belt driven stepper motors with high torque timing belts
Tilt Limit
Internal, fixed stops, adjustable soft limits
Repeatability 0.25º
Material
Housings - Aluminum, Hardware - Stainless Steel
Exterior Color / Finish
White Marine Powder Coated (other colors & custom colors/private labeling upon request)
Environmental Enclosure
Gasketed & sealed, IP-66 rated
Operating Temperature
-40˚ to 122˚F (-40˚ to 50˚C) with heaters
Position Feedback
Motor pulse count and optical position sensors, position resolution to 0.01º.
CAMERA HOUSING
Environmental Enclosure
O-ring seals and pressurizable (5 psi max)
Heaters
Camera housing heater(s) (thermostatically controlled)
Hardware/Wiring
Stainless hardware and concealed wiring
CONTROL
Communication modes:
Ethernet TCP/IP for each camera and positioner control. Supports QuickSet PTL-11 and Pelco-D Extended command & control protocols,
Camera interface board required for each specific camera. Basic test software for Windows™ provides capability to configure, test, and
operate the Pan & Tilt 32 Preset positions - each storing azimuth, elevation, zoom, & focus. 2 tours of 63 steps of 32 presets with easy
insert editing capability. Capability of entering absolute angle offsets to align pan and tilt platform to user coordinate base. Align local
coordinates to global coordinates. Automatic calibration as required using internal optical position sensors.
™
Windows and
Microsoft are registered trademarks of Microsoft Corporation.
