- 4 -
Figure 4
Twist and
Secure
FOR OPTIONAL PENDANT MOUNT
1. This unit includes a 1 1/2" NPT housing for a standard 1 1/2"
NPT pipe. The RH7C can be used with other brackets
designed with 1 1/2" male pipe threads, such as the Videolarm
WM20G and WM20 wall mount brackets.
2. Attach the housing coupling (Figure 3).
NOTE:
Pipe threads should be clean and rust free. Use a
sealer (such as Teflon™ tape or silicone sealer) on the
threads.
Wiring Color Code for Power
1
Camera Power (24 VAC)
Red
2
Camera Power (24 VAC)
Orange
3
Accessory Power (24 VAC)
Yellow
4
Accessory Power (24 VAC)
Green
POWER
4. Attach the wires from the wall to the connector provided, using the
wiring color code chart as a guide.
5. Once all wiring connections are made, place the wires inside the
wall mount bracket and close the access door. Secure with the
screw removed earlier.
6. Clean the outside of the dome.
Figure 2
Access panel
3. Open the access door on the bottom of the wall mount by
loosening the screw nearest the mounting plate (Figure 2).
Figure 3
Add thread
sealing tape
1. Mount the housing assembly to the mounting bracket and
housing coupling. A safety cable is included with the housing to
temporarily hold it while making wiring connections. Loop the
safety cable over one of the set screws on the housing coupling
and make the appropriate connections using the (2) screw-down
connectors supplied.
2. Undo the safety cable and twist the housing onto the housing
coupling. Secure all (3) setscrews provided on the housing
coupling (Figure 4, next column).
3. Clean the outside of the dome.
