- 4 -
FOR INDOOR PENDANT, PID8C
1. Select desired location to install housing.
2. The housing coupling is designed for a 1.0” NPT thread pipe.
Install the required length of pipe. Feed all power, control and
video wires through the pipe leaving approximately 12” of extra
wire extending from the end.
3. Install the housing top to the 1” pipe. Feed all wires into housing
(Figure 5).
4. Attach the quick release bracket for the unitized camera system
(See page 2).
5. Make electrical connections to the bracket, trim ming wire leads as
required.
6. Clean the inside of the dome. Reattach the hous ing dome and
secure the (3) captive screws. Do not over tighten the screws.
Figure 13
Parts List
1. Housing
2. Housing Coupling
3. Housing Packet
a. (2) Mates for screw down connectors (not supplied with
indoor units)
b. (1) Adapter plate
c. (8) 1/2" standoffs
d. (8) 8 x 32 x 3/8" Mounting screws with star washers
e. (3) 6 x 32 x 3/8" Mounting screws with star washers
f. (2) 1/4 x 20 x 3/8" HH Bolts
g. (2) 1/4” Flat washers
h. (2) 1/4" Split Lock washers
i. Instruction Manual
j. (2) Jumpers
Feed all wiring
into housing
