Monzana 4250525362640, Инструкция по эксплуатации, Страница: 10 / 36

www.DeubaXXL.de
10
Before commissioning
1. Remove the solar shower parts from the packaging.
2. Check that the delivery is complete.
3. The solar shower must be fixed to a solid surface or concrete base to ensure that its
stability and safety are maintained. Be sure to position it correctly when drilling before
damaging your floor. Sketch out the desired location beforehand.
The solar shower is equipped with a base and four prefabricated drilling arrangements
for screw installation on solid ground. Make sure the screws are tight. The filled solar
shower is heavy and a fall could have dangerous consequences.
4. Please install the solar shower in a place where it has maximum sunshine hours.
Important warning when drilling:
Before drilling, make sure that there are no gas, water or power lines at the drilling site.
Installation by qualified personnel only. Be sure to pay attention to the condition of the
ground, as the fixing material supplied is not suitable for all types of ground. Ask your
supplier for suitable screws and dowels for the respective soil conditions.
The manufacturer accepts no liability for an improper wall-plug connection and any
resulting damage.
Cleaning and maintenance
If the shower no longer functions properly after some time, the spray or inlet or outlet
openings may be blocked. Regular maintenance and cleaning is therefore necessary to
ensure that the shower runs smoothly. It is quite normal for a deposit to form on the
shower as the water evaporates. Environmental influences also lead to dirt deposits.
The shower should therefore be cleaned at regular intervals. This increases the service
life on the one hand and effectiveness on the other. To remove deposits and dirt from
the shower, rub the housing or fittings with a soft damp cloth. Only use clear water
and never cleaning agents. Rinse the openings and the showerhead with clear water to
remove any dirt.
Do not use detergents or other solutions to remove the dirt. Carefully maintain the
unit. Check that moveable parts function properly and do not clamp, that parts are
broken or damaged in such a way that the function of the device is affected. Have
damaged parts repaired before using the unit. Many accidents are caused by poorly
maintained equipment.