12
13
www.Deuba24online.de
www.Deuba24online.de
The hole of hexagonal socket must always be put
The vent of motor housing can not be covered
Only original parts can used in this machine.
The carbon brush must be checked and
the brush worn out.
motor housing.
(Picture.2) Pull out the plate and replace the
carbon brush.
Picture. 1 Picture. 2
5. MAIN COMPONENTS
SINGLE MIXING TOOL
CO (1)
Mixing tool (Paddle)
CO (2)
CO (3)
Electronic speed regulator
CO (4)
CO (5)
Switch Rest-Lock Knob
CO (6)
Start Switch
Motor Housing
Model
DBRG002
Rated Voltage
110V~230V
Rated input
Power output
950W
525W
Rated no - load speed 0-1100/min
Mixing diameter
1200mm
6. OPERATION
1 SINGLE MIXING
(Picture 1): Take out the two parts of the mixing
tools from the carton.
(picture 4): Put the mixing tools to the outlet
(Picture 5): Turn the screw of the mixing tools to
21.
product.
Picture. 1 Picture. 2 Picture. 3
Picture. 4 Picture. 5
materials, such as high density mortar, dried
building materials, tow or more kinds mixed
materials.
2. CAUTIONS
unpredictable result if you do not follow it! For
people and machine safety, please obey it!
1.
2. DO operate the machine in the suitable
working space!
3. DO keep other persons away from the working
space!
4.
when the machine operated in the amp
working space!
5. DO check the power source / voltage is same
as showed on the machine label’s!
6.
or not!
7. The machine CANNOT be over loading!
8. The electrical cable CANNOT be too far away
the machine, CANNOT pull the cable to
disconnect the plug from the socket directly!
9. DO only use no scratch, no defected cable with
plug!
10.
machine is out of work, maintenance or
11.
pointless than 21°C;
12. DO NOT use solvents for cleaning the tools!
Unless it will have explosion dangerous!
13. DO NOT install and operator the machine in
Unless it will have explosion dangerous!
14. DO NOT use the slide or movable mixing
drum!
15.
in the mixing drum or other drums!
16. DO NOT run idle of the machine!
17.
is stopped! DO NOT touch into the mixing
18. DO NOT star the machine when the dried
19. Please wear goggle and ear cap when
20. DO use only original spare parts for the
machine maintenance!
This appliance is not intended for use by
persons (including children) with reduced
or lack of experience and knowledge,
unless they have been given supervision or
by a person responsible for their safety.
Do not touch in any case the Mixing tool once
3. MIXING TOOLS CHOICE
viscous materials, mortar, quaz sand mixed
ethoxy line, heat proof paints etc, it is also
suitable for thin materials;
4. MAINTENANCE
Correct maintenance for the machine can prolong
the working life; The handle switch must always
The mixing tools should be cleaned when the
clean the mixing tools well. DO not fore any
mechaincal stress in the machine, such as POUND,
because it will be unavoicdable damaged;
5
6
4
3
2
1