Monument Grills 86030, Инструкции по сборке и эксплуатации

Страница: 26 / 27

‐ 26 ‐
start 2nd feeding, off 15s and on 30s feeding, temperature less than 135
℉
6 min later, startErL protection.
9.Trouble Shooting
Failure description Failure diagnosis troubleshooting
Ignition fails There is fuel in the fire cup but it is
not ignited
Turn the dial off and on and try to ignite
again
No fuel in the fire cup because the
fuel pellet is too large to enter the
feeder
Change to smaller fuel
The feed screw stops Check whether the circuit is abnormal or
change the feed motor
The ignition rod does not work Check whether the circuit is abnormal or
change the ignition rod
Err” shows on the
LCD
Failure of the sensor in the grill Check or change the sensor in the grill
Low temperature
protection
Detection temperature less 135
℉
for 6 min and power off and
display show ERL Shut off the display, unplug the power
and plug the power again, then start
device
High temperature
protection
Temperature higher then
615
℉
power off and display show
ERH,fan keep running 10 min and
temperature decrease to 130
℉
and shut off
Note: after failure, the control board must be reenergized and reset.
10.Pellet Hopper Clean-out
If grill will be left un-attended for a long period of time, we recommend you remove unused
pellets.
Always store wood pellets away from heat and in a dry location.
1.Turn the screws of the clean-out baffle
2.Open Hopper Clean-our baffle
Not: Make sure to hold a pail or bag in place before emptying pellet