EN - 15
• Cut off the main gas supply and unplug
the appliance from the mains electrical
supply.
• Remove the burner caps and the
adapters.
• Use a 7 mm spanner to unscrew the
injectors.
• Replace the injector with the ones from
the gas conversion kit, with the correct
diameters for the type of gas that is
going to be used, according to the gas
injector table.
Adapter
Spanner
Adapter
Cup
Burner
cap
Grill Injector
The grill injector is held in position by a
single screw on the tip of the burner. This
screw is already visible. Remove the screw,
pull the grill burner towards you and the
injector will be visible on the rear surface of
the oven cavity.
Screw
Grill burner
Remove the injectors using a 7mm
spanner and replace the injector with the
ones from the spare set. Make sure you
use corresponding diameters suitable to
the type of gas that is going to be used,
according to the information chart (which is
also supplied in the gas conversion kit).
Oven Injector
The oven burner is held in its cradle by
a single clip on the left-hand side of the
burner. Pull the clip towards the left and,
with your other hand, lift the burner up
holding from the thermocouple/spark plug
holder. The injector is on the right-hand
side of the burner cradle. Repeat the same
procedure for both the Main and Top Oven
(if present) burners.
Injector
Clip
Remove the injectors using a 7mm
spanner and replace the injector with the
ones from the spare set. Make sure you
use corresponding diameters suitable to
the type of gas that is going to be used,
according to the information chart (which is
also supplied in the gas conversion kit).
Adjusting the minimum flame position
First of all, make sure that the appliance
is unplugged from the mains electrical
supply and that the gas feed is open. The
minimum flame position is adjusted with a
flat screw located on the valve. As shown
in the figures; for valves with a flame failure
safety device, the screw is located on the
side of the valve spindle and for valves
without a flame failure safety device, the
screw is located inside the valve spindle. To
make adjusting the flame position easier,
we recommend that you remove the control
panel (and the micro switch if your model
has one) during the alteration. The bypass
screw must be loosened for conversion
from LPG to natural gas. For conversion
from natural gas to LPG, the bypass screw
must be tightened.
