montpellier CT750 Скачать руководство пользователя страница 5

Safety cut-off 

If one or more of the cooking zones are accidentally left on, a safety cut-off will activate after a

certain period of time. The length of time depends on the set power level for that zone. The table on
the right gives the time limits for each power level.

If more than one zone is operating when one of the zones reaches its safety cut-off point, only the

zone that has reached its safety cut-off point will switch off.

fig.3

fig.4

fig.5

Switching off the ceramic hob

1. Press the ON/OFF button, the hob will switch off. It is possible to turn the hob off at any time
by pressing the ON/OFF button.
2. Press the up or down buttons to 0, then hob will switch off.
After a zone is switched off, the corresponding heat level display will show a flashing letter “H” .
This means that the temperature of the zone is above 60°C and is therefore still high enough to
cause injury.

When the temperature of the zone falls below 60°C the letter “H” will go out. It is still possible

to burn yourself on a hob zone, even when its temperature has dropped below 60°C.

IMPORTANT

: The residual heat indicator will disappear if the mains supply to the product is cut.

Locking the ceramic hob

To lock the ceramic hob, press the safety lock button (fig. 4) while the appliance is switched on. 
With the safety lock activated, all buttons on the control panel will be disabled, except the 
ON/OFF button. To disable the safety lock feature, press the safety lock button again. And you 
are then able to adjust the heat level of any zone on the hob.

Time limit (hours)

Power level

1
6

2
6

3
5

4
5

5
4

6

1.5

7

1.5

8

1.5

9

1.5

3.

Timer

Your hob has a timer which you can set (from 1 to 99 minutes) for each cooking zone. At the end of 
the countdown period, a buzzer will sound and the relevant cooking zone will be switched off. 

Select the cooking zone (fig. 2) and heat level (fig. 3).

Press the timer button (fig. 5), and then use the up and down buttons to set the countdown time.

Each time the timer up or down button is pressed, the timer display will increase or decrease in 1

minute increments.

fig.6

DUAL COOKING ZONE 

Open the DUAL COOKING ZONE ,the inner ring is working, press the DUAL 
COOKING button (fig. 6), the outer ring is working.

Содержание CT750












Отзывы: