17
will not work.
1.
To use the upright vacuum cleaner, ensure that the handheld vacuum cleaner is
connected with the extended and floor brush rightly.
2.
Press the power switch on main handle or press the power switch on handheld
vacuum cleaner to alternate between settings (I) (normal power), (II)(max
power) and off.
Empty and clean the dust container and dust filter
Note: to get the best performance, empty the dust container and clean the dust filter
after 5 cleanings.
1.
Remove the handheld vacuum cleaner from the unit. Press down the release
button to remove the handheld vacuum cleaner.
2.
Push down the dust release button. Empty the dust from the dust container.
3.
Press down the release button of dust container to remove the dust container
from the handheld vacuum cleaner.
4.
Rotate the dust container upper cover towards the
“unlock”
marking and take out
of the upper lid. Then take out of the dust filter assembly.
5.
Take out the upper dust HEPA filter and the plastic cyclone filter. Then wash them
and dry naturally. After dry completely, the put back in the machine.
Do not
use
a washing machine to clean the dust filter assembly. Do not use a hair dryer to
dry it.
Air dry only.
6.
Replace the dust filter assembly back into the dust container and push the dust
filter assembly to fix firmly in the dust container.
NEVER
operate vacuum
cleaner without dust filter assembly in place.
7.
Attach the dust container assembly to the handheld vacuum cleaner.
CAUTION
: The suction inlet must be open and free of any obstructions at all times.
Otherwise, the motor may be overheat and could be damaged.
Note: it is recommended that the filter should be cleaned or replaced, and the
cyclone system should be cleaned every three(3) to six(6) months depending on
usage to ensure best performance of the vacuum cleaner. The power brush rolling
bar should be checked from time to time, and the hair etc should be cleaned in
time.
In case of wrong operation, such as the power brush rolling bar is blocked by hair
etc, or the main vacuum motor inlet is jammed, or the battery is too hot, etc.; the
system may be protected, and use the charger to activate it. In case the problem
still exists, present it to a qualified agent for repair or maintenance.
