Removing the door:
The PL42DF* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch
the door buckles and, remove the door. Replace in reverse order.
Remove the Horizontal Access Panel:
Figure 23. Removing and installing the Horizontal Access Panel
Locate the Door Buckles:
Step 2:
Step 1:
Remove the Horizontal cover
by placing fingers in both
finger holes, then pushing
away from you and lifting
out. Place it aside during
maintenance or cleaning.
Install in reverse order.
Remove the Horizontal Access Panel:
2
Step 5:
Ensure the tool is firmly in
the lower end of the slot as
shown, Then pull toward
you (Caution: hold the tool
securely).
3
Step 6:
Pull hard if necessary
to release the spring
tension. (Caution: The
latch springs back with
force, hold the tool
securely).
4
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 23c.
Figure 23d.
Figure 23e.
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 23a. Door buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under
door frame as shown.
Figure 23b.
Step 3:
Finger Holes
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
Page 24
PL42DF* Indoor Gas Fireplace
XG0217 - 160215.1
Installation
Section 8: Installing & Removing the Door
