Page 7
MD38-BV Homefire
Installation
Removing and Installing
the Insert
You may
remove the insert
to protect it from theft and damage
during construction.
1.
Remove the two machine screws (1 left & 1 right) at the top of the
insert that attach the insert to the shell.
See Inset 1.
2.
Remove the fresh air flex from the collars on the shell.
See Figure
9.
Important: Be careful not to damage the fresh air flex
during removal or storage.
3.
Remove the 4 machine screws that hold the venting plate to the
insert.
4
. Remove the insert by tipping the top of the insert outward and
lifting the tabs past the slots in the bottom of the shell.
See Inset
2.
Store the screws and clamps in a safe place to ensure that they are
not lost.
To
re-install the insert
simply reverse the steps above.
Figure 9.
MD38-BV insert.
INSET 1
Tab
INSET 2
Mounting
Bracket
Fresh Air
Flex (4" dia.)
High temp.
silicone seal
Venting Plate
Front
Slot
Removing and Installing
the Door
Removing the door surround:
The door surround is held in place by two metal clips at the top, and
one magnet on each side. To remove the surround, pull the bottom
outwards and lift upwards until the slots "A" are clear of tabs "B" in the
door. You may need to use a flat screwdriver to pull the door surround
outwards.
(See figure 11a).
Removing the door:
Remove the machine screws along the top of the door, and then pull
the door outwards and upwards until it is clear of the door rail.
(See
figure 11b).
Ensure that a good seal is maintained when installing the
door.
Figure 11a.
Removing or installing the door surround.
Glass door
and frame
Door surround
Tab 'B'
Slot 'A'
Magnet
Pull bottom of
door surround
outwards and
upwards.
Glass door
& frame
Figure 11b.
Removing or installing the glass door.
