7
Attach the revolving plate to the support arm
using four M8 x 20 mm hex bolts, washers
and wing nuts.
NOTE: Use only the top set of holes in the
revolving plate.
TIP: Rotate the revolving plate a quarter of a
turn so that the top set of holes are easier to
access when attaching the support arm.
Carefully turn the revolving 3-tier tray upside
down. Make sure it is on a flat, stable
surface.
Attach the revolving 3-tier tray to the
other side of the revolving plate using four
M8 x 20 mm hex bolts and washers.
NOTE: Use only the bottom set of holes in
the revolving plate.
TIP: Again, rotate the revolving plate a
quarter of a turn so you have better access
to the bottom of the revolving 3-tier tray.
ATTENTION: This next step may require
two people to make this transition and
then to insert the support arm into the
extension bar.
Carefully turn the revolving 3-tier tray with
the support arm upright.
Insert the top support arm into the extension
bar. Attach using two M8 x 70 mm wing bots
and wing nuts. Tighten securely.
