ETL model no. :5VSR60
For Canadian installation in both flush and down-
rod mode the safety cable must be installed into
the house structure beams using the 3” lag screws
provided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
7
8
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.
CCaannaaddiiaann m
moouunnttiinngg oonnllyy
Safety Cable
Lag Screw
10
Lag Screw
Washer
Lock Washer
Safety Cable
Place blade holders onto blades aligning holes
in blade holder with holes in blade. Make sure
that the side of the blade you select is facing
downward. Install 3 screws and fiber wash-
ers to back side of blade as shown. Tighten
screws securely. Repeat this process 4 more
times until all blades are assembled.
12
For installation with
light kit, go to next
step 16.
For installation
without light kit, go
to step 14.
9
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Make sure that all exposed wiring is
secured inside wire nuts. Note: Wires from
house may vary in color and may not
include ground wire. After wiring is com-
pleted, gently push wires into junction box
with wire nuts pointing upward.
Install the light kit plate to the motor by twist-
ing clockwise and install the screw removed
from step 16 to the light kit plate. Tighten the
3 screws securely.
17
Lift canopy and install knurled nuts as
shown. Tighten the knurled nuts securely.
The canopy should adjust for any irregu-
larity in the ceiling or Outlet box.
11
Remove 2 cardboards pre-installed
into the fan body. Install blades to
motor using the motor screws pro-
vided. Tighten screws and washers
by using the hex-nut driver provided.
13
Remove 3 screws from the motor.
Save the removed screws for later
use with light kit.
14
Install the no light cover by using the
3 hex nut screws provided.
Use the hex nut driver to tighten the
3 hex nut screws.
15
Loosen the 2 screws and remove 1
screw from the motor. Save the
removed screw for later use.
16
