© 2013 Monte Carlo Fan Company
11/1/2013
4
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
11
Lift canopy allowing the 2 studs to
protrude through the canopy.
12
Next lift the canopy disk and install
knurled nuts as shown. Tighten the
knurled nuts securely. The canopy should
adjust for any irregularity in the ceiling or
Outlet box.
13
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to White
(Neutral) wire from house. Connect Ground leads from
mounting bracket and downrod to Ground lead from
house.
Refer to Safety Tips section of manual.
10
Canopy disk
House
Fan
Blue
Black
White
Green
Black
White
Ground
Place blade holders onto blades aligning holes
in blade holder with holes in blade. Make sure
that the side of the blade you select is facing
downward. Install 3 screws and fiber washers
to back side of blade as shown. Tighten
screws securely. Repeat this process 4 more
times until all blades are assembled.
Install blades to motor using the 10
motor screws provided. Tighten
screws securely.
14
15
Install switch cap to fan using the 3
screws provided. Tighten securely.
Setting the reverse switch in the
left hand side will result in down-
ward airflow and setting the
switch in the right hand side will
result in upward airflow.
16
Reverse switch
Install rubber pad between fan
body and canopy.
18
Remove every other screw as circled
and save for later use.
17
Flush Mount Installation
