Monte Carlo Fan Company 5LDO52 Series, Руководство пользователя и инструкция по установке

Страница: 4 / 9

4
7 8 9
10 11
© 2022 Monte Carlo Fan Collections
3/2022
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning:
Failure to align slot on ball with
tab may result in serious injury.
Important
: If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper than 20º.
Safety cable must be installed into the
house structure using 3” lag screws,
washers, and lock washers provided,
required for outdoor applications and in
Canada (All fans installed in Canada), and
for USA fan and light kit combinations
over 35lbs.
Make sure that when the safety cable is
fully extended, the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
:
If installing the secondary support
safety cable in the U.S., do not remove
knockouts in the outlet box.
Make wiring connections using wire
connectors provided as indicated above.
White from fan to White (Neutral) from
house. Black and Blue from fan to Black
(Live) from house. Connect all green
grounded wires to Grounded wire from
House. Make sure that no filaments are
outside of the wire connectors.
After making the wire connections, the wires
should be spread apart with the grounded
conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of
the outlet box. The splices after being made
should be turned upward and pushed carefully
up into the outlet box.
Lift Canopy allowing the 2 studs to
protrude through the canopy.
Next lift the cover ring and install knurled
nuts as shown. Tighten the knurled nuts
securely. The canopy should adjust for
any irregularity in the ceiling or Outlet
box.
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
SAFETY CABLE INSTALLATION
Lag screw
Safety cable
Washer
Lock washer
Go to step 19 to finish
installation
Wall
switch
Power
source
White
(Neutral)
Black
(Live)
Ground/Green
Black
Blue
White
Grounded
wires
Ungrounded
wires
Tab
Slot
Stud