Loosen 3 screws with key slots and remove the
screw without key slot.
25
Take plate and place over the 3 screws with key
slots and twist to hold in place. Replace the
screw removed and tighten all 4 screws secure-
ly holding the plate.
26
Loosen 3 screws with key slots. Attach fitter by
placing over screws and twisting clockwise into
place. Tighten all 3 screws securely.
28
Plug white wire from fan to white wire from
light kit. Then plug black from fan to black from
light kit.
27
Attach glass by locating dimples in light kit and
aligning it with the groves in glass and twisting
clockwise till tight.
30
Install the 2 50 watt halogen bulbs. Do not
touch bulb surface as oily residue from skin can
cause the bulb to explode.
29
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
20
Attach blade brackets to blades using the blade
bracket screws and washers provided.
23
Remove the shipping stabilizer plate and throw
away (see insert). The screws, washers and
motor pads are pre-installed to the blade hold-
ers. Attach blade assembly to motor and tighten
screws securely.
24
Make wire connections as per above diagram.
Connect the white wire from the fan to the
White or Neutral wire from the power source.
Connect the black wire from the fan to the
Black or hot wire from the power source.
Connect all Green / Yellow wires from the fan,
Downrod and mounting bracket to the Ground
wire from the house.
19
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Lift Canopy to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
22
Re-install safety bar removed in step. 3 by
placing safety bar on screws, sliding into place,
and tightening the 2 screws.
21
