© 2013Monte Carlo Fan Company
6/15/2013
5
Connect white wire from fan to white
wire from light fixture. Then connect
blue wire from fan to black wire from
light fixture.
Align keyslot holes of the light kit
plate and twist to lock. Install screw
removed in step 23 and tighten se-
curely.
24
25
Install 3 x 40 watt candelabra base
bulbs, Bulbs included.
WARNING:
Over lamping the fan will result
in the fan lights shutting down
until the proper wattage of bulbs
are installed. Reset the lights by
turning off the wall switch,
breaker,or by remote. Replace
bulbs with the correct wattage
bulbs, turn the power on.
26
Attach glass to fan by twisting clock-
wise to lock.
27
Lift canopy and install knurled nuts as
shown. Tighten the knurled nuts securely.
The canopy should adjust for any irregu-
larity in the ceiling or Outlet box.
20
Check motor for shipping stabilizers and
remove if present. Insert blades to fan fly-
wheel and place the reinforce plate onto
the blades as shown.
21
Tighten blade using the screws in hard-
ware pack, repeat this procedure 4 more
times.
22
Loosen 2 screws and remove one screw.
Keep the removed screw for later use.
23
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box. The splices after being
made should be turned upward and pushed carefully up
into the outlet box.
19
