5
11
12
13
14
15
16
© 2020 Monte Carlo Fan Collections
2/2020
Lift Canopy, aligning the key holes with
the preinstalled screws on canopy and
turning clockwise till tight, and then
reinstall the set screw removed in step 3.
Install canopy ring by locating its groove
with the screws on canopy and turn
clockwise till tight.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Attach light pan onto the plate on motor,
Place light pan over the lead wires from
fan, aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
Loosen 2 and remove 1 preassembled
screw from light pan. Save screw for later
use.
Remove nut, rubber washer, hex nut and
finial from LED light fixture. Keep parts
Insert blade into the slot on flywheel.
Install blade with a blade supporting plate
by the screws provided, aligning each of
the holes as shown and tighten all screws
securely. Repeat this process for
remaining blades.
Note
: Make sure the side with a label
“This side up” is installed upward.
Groove
Light pan
Blade
Blade supporting plate
Plate on motor
Nut
Finial
Rubber washer
Hex nut
This
side
up
Est
e
lado
hacia
arriba
Haut
This side up
Содержание 4LMR56 D Series
Страница 10: ...Mar 2020 ...
