© 2011 Monte Carlo Fan Company
12/28/2011
4
Loosen set screw and then remove
cross pin from yoke for downrod
to slip into yoke. Keep the cross
pin for later use.
12
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be in-
stalled into the house structure beams using the
3” lag screws,washers, and lock washers. pro-
vided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
18
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Re-place the upper motor housing onto
the fan motor. Be sure the holes are all
aligned.
Note: Align the hole on top housing la-
beled “REVERSE” with the reverse switch.
10
Tighten the screws removed from
step 5. Tighten securely.
11
Place the canopy over the downrod
as shown above.
13
Thread the leadwires and safety
cable through the downrod.
14
Place the downrod into the yoke
aligning the holes on downrod with
the holes on the yoke and then re-in-
stall the cross pin removed in step
12. Tighten securely.
15
Tighten the set screw on the yoke.
16
Hang the assembled fan from the
mounting bracket. Be sure to turn
the fan to lock the ridges from the
fan and mounting bracket in place.
17
Set screw
Cross pin
Reverse switch
Reverse switch
