4
© 2013 Monte Carlo Fan Company
11/15/2012
7
8
9
10
11
12
Install the motor assembly with the blade
assembly using the screws provided.
Tighten all screws securely.
Replace the top plate removed in step 5,
aligning holes by turning the plate
clockwise till lock, and then reinstall the
screws removed in step 5. Tighten all
screws securely.
Remove preassembled keeper pin and
cross pin from downrod.
Place downrod over canopy and top
housing.
Thread lead wires and safety cable from
motor assembly through downrod.
Slip downrod into motor housing yoke,
aligning holes and install cross pin and keeper
pin.
Insert cross pin through yoke and downrod
until point appears on the other side, and
insert keeper pin on cross pin.
Pull the downrod up tight against the cross
pin, and then evenly tighten the downrod set
screws on motor housing yoke.
Place top housing on motor assembly.
Warning
: Cross pin and keeper pin must be
installed securely, failure to install them will
result in serious injury.
Keeper pin
Cross pin
Downrod
Canopy
Top housing
Downrod
Downrod
Keeper pin
Cross pin
Downrod
Yoke
Top housing
Top housing
Canopy
